Drive Technologies Inc DBA Treehouse

Install 60a 240v circuit in 100a main panel. hardwire ev charger on interior garage wall

55 Newton StExcelsiorcomplete#EV charger

Solar permit: installing 14 solar pv modules, 250 watts per module, total no. of rating 3.5 kw. mounted: roof, ballasted: n, including 1 energy storage unit, with 11.5 kwh each in capacity, ess units will not be closer than 3 feet | install (1) tesla powerwall 3 on ga

1683 23rd AvSunset/Parksideissued#Solar & batteries

Install a 60a 2-pole breaker in the 100a main service panel. hardwire ev charger on interior garage wall

16 Winfield StBernal Heightscomplete#EV charger

Install a new 60a ev circuit in the existing exterior 125a meter/main panel to supply the charger. hardwire ev charger just to left if meter/panel on exterior garage wall

60 Clipper StNoe Valleycomplete#EV charger

Installing new 100a subpanel

1372 York StMissioncomplete#Electrical

Install a 60a 240v circuit in the 125a subpanel.hardwire the chargepoint home flex charger onto the exterior side wall of the house's stairs.

451 Naples StExcelsiorcomplete#Electrical

Solar permit: ballasted: n, including 1 energy storage unit, of 240 vac, with 13.5 kwh each in capacity, ess units will not be closer than 3 feet | installation of tesla powerwall 3 with gateway and remote energy meter

710 05th AvInner Richmondcomplete#Solar & batteries

The existing juicebox charger will be relocated from the pillar to beside the main service panel, with wiring in new surface-mounted conduit between the panel and gas pipe. a new 50a circuit will be added to the main panel for the iotecha evee charger, running through the gateway and solar combiner box, then through the existing conduit to the pillar, where the evee will be hardwired.

1586 25th AvSunset/Parksidecomplete#Solar & batteries

The proposed wire route is to run wiring from the 200a main panel in the basement, through the basement ceiling in surface-mounted conduit, then into the garage. inside the garage, the wiring will continue in surface-mounted conduit along the garage wall and ceiling before exiting to the left exterior garage wall. the charger will be hardwired near the front corner behind the fence.

2590 Union StMarinacomplete#Electrical

We will install a tesla gateway 3 and powerwall 3 in your garage and this new energy storage system will be configured to provide whole home backup in the event of an outage. your existing solar system will be included in the backup and will be monitored by the tesla remote energy meter.

710 05th AvInner Richmondcomplete#Solar & batteries

Equipment to install install a new 60a, 240v circuit in the existing 125a garage panel. hardwire the customer-provided rivian wall charger. proposed installation location & wire run run conductors directly to the left of the garage panel. mount charger on the interior garage wall.

20 Gateview CtWest of Twin Peakscomplete#Electrical

Install a 30/50 quad breaker in the existing 125a main panel, utilizing the existing 30a 240v dryer circuit. hardwire the grizzl-e classic ev charger.

139 10th AvInner Richmondcomplete#EV charger

Install a 60a subpanel adjacent to the 100a main panel and relocate multiple 120v circuits into it. install a new 60a, 240v circuit in the main panel for an iotecha liva charger.

140 Everglade DrSunset/Parksidecomplete#Electrical

Nstall iotecha liva charger on interior garage wall using the available, pre-wired 40a 240v circuit from the 100a subpanel. verify that existing wiring is copper, appropriately sized for 60a (minimum #8 awg), and installed per nec requirements. derate the charger to a 32a power draw to accommodate the circuit size of the existing wiring.

1911 31st AvSunset/Parksidecomplete#Electrical

Install ev charger on left interior garage wall

1586 25th AvSunset/Parksidecancelled#EV charger

Install new 60a subpanel adjacent to existing 100a main panel. relocate multiple existing 120v breakers to new subpanel to create space in the main panel. install a new 60a, 240v circuit from the main panel to the ev charger. hardwire the iotecha liva ev charger. on interior garage wall

337 Amazon AvExcelsiorcomplete#Electrical#EV charger

Remove the existing 50a stove circuit from the 100a bridge panel, as it is no longer needed. a new 15a 120v stove igniter circuit will be installed in the 100a qo subpanel.gfci-protected receptacle will be installed in the bottom right corner behind stove

511 Congo StWest of Twin Peakscomplete#Electrical

Install (1) 30/50 quad breaker in the 125a main panel, utilizing the existing 30a oven breaker. run wire from the 50a evse into the garage where we will hardwire the pulsar plus charger on the interior garage side wall.

3134 Baker StMarinacomplete#EV charger

Remove the 30a dryer circuit and install a 20/50 quad with the existing 120v circuits and a new evse circuit. the proposed wire route is to exit from the panel inside, run a surface-mounted conduit along the exterior side wall, enter the garage, and hardwire the emporia pro charger to the interior left side wall. we will enable the vue for load monitoring. de-rate the charger to 40a current draw. install the vue for load monitoring purposes.

123 Ulloa StWest of Twin Peakscomplete#EV charger

Install a 20/50 quad breaker utilizing the existing 20a, 240v circuit in the 80a subpanel. hardwire the chargepoint charger to the left of the panel, the customer would like this installed to the left of the furnace and right of the door frame. de-rate the charger to 40a current draw.

3977 19th StCastro/Upper Marketcomplete#Electrical#Heating & cooling